+86-411-86306776

24deg cutting ring connector

Mar 24, 2022

24deg cutting ring connector


The core component of the single sleeve joint manufactured according to EN ISO 8344-1 (DIN 2353) is the sleeve. Single cutting ring: three important parts of the installed joint.

image

Important advantages:

Extremely high cut in

Extremely high sealing, rust free surface

Reliable installation

Single sleeve does not require special placement


Tightening torque can be reduced by 35% by using nuts with improved surfaces. Can avoid the thread between the stainless steel material stuck phenomenon.


Single cutting ring joint function description:

As the nut is tightened, the single jacket is squeezed into the cone. Under the action of the nut, the inner edge of the cone guide single jacket cuts into the surface of the steel tube. The end face of the inner edge forms a annular projection. The steel tube is squeezed inside the joint and sealed by proper, clean pre-installation. On the other side, the single sleeve bites the steel tube by squeezing the nut. There is an additional clamping force at this position of extrusion under dynamic load. If the tube is sawed vertically and cleanly deburred, the three important parts of the installed joint can be sealed.

image

L series and S series:


L Light series: suitable for high pressure ranges up to PN 315: measurement and control technology, paper and plastics industry, pharmaceutical industry, aerospace, hydraulic equipment and coating industry.


S heavy series: suitable for heavy machinery under strong water hammer, vibration and high mechanical performance requirements. Shipbuilding, mining, chemical industry, large cooling equipment, port and lock equipment, offshore platforms, petrochemical, generally within the pressure range of PN 250-400, also up to PN 630.

imageInstallation

tube selection

saw pipe off at the right angle

debur the tube end and clean the tube

lubricate nut, ring, and thread with grease

pre-assemblly

check

final assembly



























Send Inquiry